This example describes how to customize the HAL time base using a general
purpose timer(TIM6) instead of Systick as main source of time base.
Time base duration is kept unchanged: 1ms since PPP_TIMEOUT_VALUEs are defined
and handled in milliseconds basis.
The example brings, in user file, a new implementation of the following HAL weak functions:
HAL_InitTick()
HAL_SuspendTick()
HAL_ResumeTick()
This implementation will overwrite native implementation from stm32f4xx_hal.c
and so user functions will be invoked instead when called.
The following time base functions are kept as implemented natively:
HAL_IncTick()
HAL_Delay()
HAL_IncTick()
When user pushes the Tamper push-button, the Tick increment is suspended if it is already
enabled, else it will be resumed.
In an infinite loop, LED1 toggles spaced out over 1s delay.
@note Care must be taken when using HAL_Delay(), this function provides accurate delay (in milliseconds)
based on variable incremented in TIM6 ISR. This implies that if HAL_Delay() is called from
a peripheral ISR process, then the TIM6 interrupt must have higher priority (numerically lower)
than the peripheral interrupt. Otherwise the caller ISR process will be blocked.
To change the TIM6 interrupt priority you have to use HAL_NVIC_SetPriority() function.
@note The application need to ensure that the TIM6 time base is always set to 1 millisecond
to have correct HAL operation.
@note The connection of the LCD reset pin to a dedicated GPIO PK7 instead of the STM32F469 NRST pin may cause residual display on LCD with applications/examples that do not require display.
