In this example, one EXTI line (EXTI0) is configured to generate
an interrupt on each falling edge.
In the interrupt routine a led connected to a specific GPIO pin is toggled.
In this example:
- EXTI0 is connected to PA.00 pin
- when falling edge is detected on EXTI0 by pressing User push-button, LED1 toggles
On STM32469I-DISCOVERY:
- EXTI0 is connected to User push-button
In this example, HCLK is configured at 180 MHz.
@note Care must be taken when using HAL_Delay(), this function provides accurate delay (in milliseconds)
based on variable incremented in SysTick ISR. This implies that if HAL_Delay() is called from
a peripheral ISR process, then the SysTick interrupt must have higher priority (numerically lower)
than the peripheral interrupt. Otherwise the caller ISR process will be blocked.
To change the SysTick interrupt priority you have to use HAL_NVIC_SetPriority() function.
@note The application need to ensure that the SysTick time base is always set to 1 millisecond
to have correct HAL operation.
@note The connection of the LCD reset pin to a dedicated GPIO PH7 instead of the STM32F469 NRST pin may cause residual display on LCD with applications/examples that do not require display.
The LCD clear can be ensured by hardware through the board's power off/power on or by software calling the BSP_LCD_Reset() function.
