STM32CubeF3

/**
  @page TSC_BasicAcquisition_Polling Touch-Sensing basic acquisition using polling

  @verbatim
  ******************** (C) COPYRIGHT 2016 STMicroelectronics *******************
  * @file    TSC/TSC_BasicAcquisition_Polling/readme.txt
  * @author  MCD Application Team
  * @brief   Description of the TSC basic acquisition polling example.
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; Copyright (c) 2016 STMicroelectronics.
  * All rights reserved.</center></h2>
  *
  * This software component is licensed by ST under BSD 3-Clause license,
  * the "License"; You may not use this file except in compliance with the
  * License. You may obtain a copy of the License at:
  *                        opensource.org/licenses/BSD-3-Clause
  *
  ******************************************************************************
  @endverbatim

@par Example Description 

Use of the TSC to perform continuous acquisitions 
of one channel in Polling mode.

When the end of acquisition occurs, the acquired data is affected to the
uhTSCAcquisitionValue variable.

STM32 Eval board's LEDs are used as follows:
  - LED1, LED2 and LED3 show the touch activity (low to high pressure)
  - LED4 toggles when an error occurs (TSC initialization, TSC start or assert).
 
@par Directory contents 

  - TSC/TSC_BasicAcquisition_Polling/Inc/stm32f3xx_hal_conf.h    HAL configuration file
  - TSC/TSC_BasicAcquisition_Polling/Inc/stm32f3xx_it.h          Interrupt handlers header file
  - TSC/TSC_BasicAcquisition_Polling/Inc/main.h                  Header for main.c module  
  - TSC/TSC_BasicAcquisition_Polling/Src/stm32f3xx_it.c          Interrupt handlers
  - TSC/TSC_BasicAcquisition_Polling/Src/main.c                  Main program
  - TSC/TSC_BasicAcquisition_Polling/Src/stm32f3xx_hal_msp.c     HAL MSP file 
  - TSC/TSC_BasicAcquisition_Polling/Src/system_stm32f3xx.c      STM32F3xx system source file

@par Hardware and Software environment 

  - This example runs on STM32F373xC devices.
  
  - This example has been tested with STM32373C-EVAL board and can be
    easily tailored to any other supported device and development board.

@par How to use it ? 

In order to make the program work, you must do the following :
 - Open your preferred toolchain 
 - Rebuild all files and load your image into target memory
 - Run the example

 * <h3><center>&copy; COPYRIGHT STMicroelectronics</center></h3>
 */